The MAX1458 Automated Pressure-Temperature Test System Concept and Schematic

The MAX1458 Automated Pressure-Temperature Test System Concept and Schematic - According to the MAX1458 Datasheet, this device is an Analog Sensor Sig

The MAX1458 Automated Pressure-Temperature Test System Concept and Schematic - According to the MAX1458 Datasheet, this device is an Analog Sensor Signal Conditioner designed to produce an

MAX1458 Automated Test System Schematicautomated pressure-temperature test system with integrated callibration and temperature compensation.

The figure below displayed this Automated Test System Concept. A concept for a low cost test system capable of testing up to 12 transducer modules connected in parallel.

It includes a dedicated test bus which consists of 2 (two) power supply line, an analog output voltage line from transducer to system digital voltmeter and two serial interface line (DIO and SCLK).

The MAX1458 can be used for parallel connections of transducers since it has three state outputs on the device.

If you want to make a simultaneous testing with 12 MAX1458 sensor modules, you can use buffer to solve the overloading data bus. Then for each transducer, a digital multiplexer will control the chip-select signal.

Follow on complete MAX1458 Datasheet, for The MAX1458 Automated Pressure-Temperature Test System Concept section just jump out to page 16 of the pdf filetype (source: maxim-ic.com). See another Sensor Conditioner in this site.

Tags: Sensor Conditioner, Sensor Datasheet, signal conditioner, sensor module,

Related The MAX1458 Automated Pressure-Temperature Test System Concept and Schematic Posts in Amplifier Category
» TDA5140A Brushless DC Motor Circuit and Datasheet
» LM348 Sine Wave Generator Circuit Diagram
» LM348 Quad Op Amp Circuit Diagram and Datasheet
» Aerial Booster Circuit Diagram for Citizens Band Project
» 200mWatt Super Tiny Amplifier using LM386 Circuit Diagram