Opel GT Protective Ignition Relay Installation Circuit Schematic

Opel GT Protective Ignition Relay Installation Circuit Schematic - The following circuit schematic shows Opel GT Protective Ignition Relay Installatio

Opel GT Protective Ignition Relay Installation Circuit Schematic - The following circuit schematic shows Opel GT Protective Ignition Relay Installation illustration.

If you find yourself a good-working ignition switch, the circuit schematic for installing the relay is as shown below:

In order to install this protective ignition relay for your Opel GT, you will need to assemble a harness with 3 short wires, 4 clip ends and 2 eyelet connectors to connect to 3 relay terminals, 1 solenoid terminal,

1 round solenoid battery post, and a round ground on the chassis. The starter solenoid will then transfer the existing connection to the new relay as shown by the circuit schematic.

For further read on Opel GT Protective Ignition Relay Installation Circuit Schematic, you may download full article in pdf here (source: opelclub.com)

Tags: Opel GT, starter solenoid, ignition relay, GT Protective Ignition,