LT1107 Output Ripple Reduction using Gain Block Circuit Diagram

LT1107 Output Ripple Reduction using Gain Block Circuit Diagram - LT1107 Micropower DC/DC Converter has a gain block A2 which can serve as a low-batt


LT1107 Output Ripple Reduction using Gain Block Circuit Diagram

LT1107 Output Ripple Reduction using Gain Block Circuit Diagram -  LT1107 Micropower DC/DC Converter has a gain block A2 which can serve as a low-battery detector, be used as an error amplifier, or linear post regulator. 

The following picture shown the Output Ripple Reduction using Gain Block of the LT1107 device.

The circuit diagrams output ripple of the LT1107, it normally 50mV at 5Vout can be reduced significantly by placing the gain block in front of FB input, according to the datasheet. 

Ripple reduction works with step-down or inverting modes as well.

For this technique to be effective, output capacitor C1 must be large, so that each switching cycle increases VOUT by only a few millivolts. 1000mF is a good starting value. C1 should be a low ESR type as well..

(source: linear.com)

Tags: Gain Block, Ripple Reduction, LT1107 Converter,

Copyright www.unboxing.eu.org