How to Wiring Glendinning Marine Engine Tachometer Sende
How to Wiring Glendinning Marine Engine Tachometer Sende - Do you have any difficulties in wiring Glendinning Marine Engine Tachometer Sender? The schematic illustrates what wires in the tachometer which can be wired to the engine processor of the boat.
First of all you need to have an #18 AWG / 2 conductor shielded wire to each tachometer sender. Please choose the black one and black with red stripes to be run to the engine processor and do not connect anything else to this wires other than the Electronic Engine Control system.
Then, make it sure that other end of each wire can be connected to the engine processor tacho terminal strip and the starboard is attached to the stbd side of the terminal strip.
These wires can be hooked to either terminal position since they are non-polarized, just make it sure that you connect to the appropriate terminal strip of each engine.
Tags: engine processor wiring, wiring tachometer sender, Glendinning Marine Engine, Electronic Engine Control, glendinning marine tachometer, tacho terminal strip, tachometer wiring diagram,