# Rangkaian Sekring (Fuse) Otomatis

To restrict / security, electric current is usually used fuse/sekring or patron is dissolved when going short (konslet) will drop out and must be repl

Rangkaian Sekring (Fuse) Otomatis - Salam Electrical Engineer yang setia membaca artikel pada blog ini. Semoga tetap bersemangat untuk belajar dan terus belajar tentang elektronika.

Pada kesempatan kali ini saya akan berbagi tentang Rangkaian Sekring (Fuse) Otomatis. Gunakan fitur Translate di sebelah kanan untuk menterjemahkan teks berbahasa inggris, selamat membaca, semoga bermanfaat.

To restrict / security, electric current is usually used fuse/sekring or patron is dissolved when going short (konslet) will drop out and must be replaced with a new one.

#### Skema Rangkaian

Skema Rangkaian Sekring (Fuse) Otomatis |

To restrict / security, electric current is usually used fuse/sekring or patron is dissolved when going short (konslet) will drop out and must be replaced with a new one.

Then, in order not to drop out of each new change means that more money out to buy, then there fuse/sekring automatically work with the reset button.

So there are problems with each short, fuse/sekring will automatic decided flow then to return it does not need to buy a new (if not broken) just press the reset the equipment will live again.

This is one of the simplest electronic fuse circuit one can make. The circuit uses only one transistor, one SCR, one push button switch and two resistors.

The value of R1 can be obtained from the equation; [Imax] X [R1] = 0.7V. R2 can be obtained from the equation; R2 = [Vs] X [1K Ohms].

This is one of the simplest electronic fuse circuit one can make. The circuit uses only one transistor, one SCR, one push button switch and two resistors.

The value of R1 can be obtained from the equation; [Imax] X [R1] = 0.7V. R2 can be obtained from the equation; R2 = [Vs] X [1K Ohms].

Wattage rating of R1 can be obtained from the equation; W = [Imax] X [Imax] X [R1].

For this circuit to work the current consumption of the load must be greater than the holding current of the SCR.

The working of the circuit is very simple. Initially the load current flows through SCR and resistor R1.The value of R1 is so selected that, the maximum load current multiplied by the resistance of R1 is equal to 0.7 volts.

For this circuit to work the current consumption of the load must be greater than the holding current of the SCR.

The working of the circuit is very simple. Initially the load current flows through SCR and resistor R1.The value of R1 is so selected that, the maximum load current multiplied by the resistance of R1 is equal to 0.7 volts.

When the load current exceeds the maximum value the voltage drop across R1 becomes more than 0.7V and switches transistor Q1 ON. Now the transistor completely bye passes the load current and the current through triac falls below the holding current.

This makes the triac OFF. When SCR is OFF there will not be any current flow through R1 and so the voltage across it falls to 0.

This makes the transistor OFF, completely isolating the load circuit.The fuse can be resetted by pressing S1.When S1 is pressed the SCR is again triggered and remains latched to conduct the load current.

Copyright www.unboxing.eu.org