Rangkaian Pemancar TV Sederhana
This Transmitter Circuit TV uses standard 1 FM modulation for sound and PAL for video modulation. Audio signal will be modulated is pre-amplified usin
Rangkaian Pemancar TV Sederhana - Salam Electrical Engineer yang setia membaca artikel pada blog ini. Semoga tetap bersemangat untuk belajar dan terus belajar tentang elektronika.
Pada kesempatan kali ini saya akan berbagi tentang Rangkaian Pemancar TV Sederhana Gunakan fitur Translate di sebelah kanan untuk menterjemahkan teks berbahasa inggris, selamat membaca, semoga bermanfaat.
This Transmitter Circuit TV uses standard 1 FM modulation for sound and PAL for video modulation. Audio signal will be modulated is pre-amplified using the transistor Q1 and associated components.
Skema Rangkaian
Skema Rangkaian Pemancar TV Sederhana |
This Transmitter Circuit TV uses standard 1 FM modulation for sound and PAL for video modulation. Audio signal will be modulated is pre-amplified using the transistor Q1 and associated components.
The transistor Q2 has two jobs: production of carrier frequency and modulation. The pre-amplified audio signal is fed to the base of transistor Q2 for modulation.
Capacitor C5 and inductor L1 forms the tank circuit which is responsible for producing the carrier frequency. The video signal is fed to the emitter of transistor Q2 via POT R7 for modulation. The modulated composite signal (audio+video) is transmitted by the antenna A1.
Inductor L1 can be made by making 4 turns of 24SWG enameled copper wire on a 6mm dia: plastic former. T1 can be a radio frequency transformer with built in capacitor. (Can be found on old transistor radio boards).
Inductor L1 can be made by making 4 turns of 24SWG enameled copper wire on a 6mm dia: plastic former. T1 can be a radio frequency transformer with built in capacitor. (Can be found on old transistor radio boards).
Antenna A1 can be a 1M long copper wire. (Experiment with the length to get optimum performance). This transmitter is working in VHF band somewhat between 50 – 210MHz. This transmitter is compatible only with PAL B and PAL G systems.
List Componet:
- R1 = 10KOhm
- R2 = 47KOhm
- R3 = 15KOhm
- R4 = 8.2KOhm
- R5 = 47KOhm
- R6 = 47KOhm
- R7 = 1Kohm
- resistor variable R8 = 75Ohm
- C1 = 10uF/25Volt
- capacitor electrolik C2 = 0.001uf/10nF
- capacitor ceramic C3 = 100nF
- C4 = 10nf C5 = 47pF (variable capacitor)
- C6 = 10nF
- C7 = 10pF
- C8 = 27pF
- c9 = 100nF
- C10 = 470uF
- c11 = 10nF
- C12 = 220uF/25Volt
- Q1 = BC547 NPN transistor
- Q2 = BC547 NPN transistor
- T1 = T1 can be a radio frequency transformer with built in capacitor. (Can be found on old transistor radio boards).
- L1 = 4 turns of 24SWG enameled copper wire on a 6mm dia: plastic former.
Copyright www.unboxing.eu.org